Female Luer Bulkhead

Video of Female Luer Bulkhead

Specification of Female Luer Bulkhead

*PP material Female Luer Bulkheads are in stock, PTFE material need to be customized with MOQ at least 2000 pieces per model, other materials can be customized with MOQ at least 5000 pieces per model, please contact customer service for more information.

*If you also need female luer-to-barb adapters to come together, please contact us freely.

Mounting Steps of Female Luer Bulkhead

Step 1. Drill 1 hole site on target panel or board, hole site diameter same or little bigger than outer diameter of male thread (1/4-28 or M10 vary from different model numbers) of the Female Luer-to-Barb Bulkhead Fitting

Step 2. Drill 2 small hole sites centering on above big hole site, hole site diameter same or little bigger than outer diameter (dia.3.0mm, depth 1.5mm) of the emboss on mounting stator

Step 3. Put the mounting stator into the 2 small hole sites, pass the Female Luer-to-Barb Bulkhead Fitting through the regular hexagon of mounting stator

Step 4. Rotate the fixing nut through the male thread of the Female Luer-to-Barb Bulkhead Fitting until well tightened

Step 5. Luer connect the Male Luer-to-Barb adapter with Female Luer-to-Barb Bulkhead Fitting until well tightened

Step 6. Connect prepared 2 pieces flexible tubes at two barbed ends

Dimension (unit: mm) of Female Luer Bulkhead

* Standard nut for female luer bulkhead adapter is LM-M10P single tooth nut, but M10*1 nut  (pps material ) is also available for purchase, which is easier for installation.

Male Luer Adapters

Luer-to-Luer Adapters

Luer-to-Thread Adapters